We are the originators of unique front license plate holders, and we have the ultimate answer to attaching a front license plate to almost any Ferrari, Maserati, Alfa Romeo, Audi, BMW, Porsche, and McLaren 12C/15C or most other vehicles without making any permanent holes in the front panel!

So whether it's a 360, a 430, a 458, California (30 series), California Turbo series, FF, Scuderia, 16M, or almost any vehicle we can accommodate the front license plate.

Please see the respective section for your particular model.

Note that Unfortunately Ferrari did not provide tow hook threads for the 308 or for the 328. Thus, we do not have an application for these two (2) models.

If you have an early Mondial or Testarossa (1983 or 1984 production years) with the small diameter tow hook we do have plate holders for those models. If you think you have a 1985 model year please look at the manufacturing date on the vehicle tag to confirm your model year so we can send the correct mounting post.

Our device screws into the existing front tow hook threads and holds the front license plate assembly! Moreover, it has been designed so as not to affect air flow into the radiator vents.

It is quite sturdy and very well made, and it solves the problem.

Supplied with each kit is a machined post to screw into the the tow hook threads and all the stainless steel hardware necessary and full instructions necessary to complete the installation.

Generally the single post models can be easily removed and can be carried in the vehicle to promptly correct a "fix it" ticket. "Oh, I just had the car waxed and forgot to put the plate on, officer"!

However please note that with the flex-mount™ assembly prompt removal is slightly more involved.

The flex-mount™ has been designed to make the front plate issue more attractive by adapting, through its available motion, to the natural contour of the vehicle body lines.

Thus, the mounting screw would be removed and the post would remain in place.

Assembly takes less than 10 minutes to set-up and to install.

It can easily be adjusted left/right of the mounting pin to suit one's individual taste and to accommodate proper intake air flow.

As part of our continuing policy of innovation and creativity we now offer our very clever plate flex mount assembly™ for many of our front plate holder models.

This unusual and very advanced mounting assembly allows the front plate assembly to move left or right of the center of the mounting pin to provide the installer with the ability to contour the license plate position to that of the vehicle body line thereby creating a seamless appearance to the vehicle!

This very unique assembly offers +/- 25 degrees of contour on either side of the assembly mounting post.

The Flex-Mount™ assembly is not applicable to all models, however, as there are many vehicles wherein our license plate mount is flush with the front panel.

We will constantly update the application listing as to which models the flex-mount™ is applicable.

The following models have been found to visually benefit from the application of our Flex-Mount™ assembly-

As we test the adaptabilty of the front plate flex Mount Assembly™ to other Ferrari models we will post the results here.

If you have a very early Testarossa with the small shaft tow hook we have the front plate holder for that model as well.


Since there are so many variations, please advise us at time of ordering which model you have, and we will then provide you with the correct plate holder for your vehicle.

The best way to order is send us the following information by e-mail. E-mail is the surest, fastest, and most convenient way to contact us.

We will send out your plate holder usually is the same day the funds are received.